Backsplash

Quartz backsplash add-on installation in San Diego County

A quartz backsplash uses a piece of the same slab material as your countertop to create a continuous stone look from the countertop surface up the wall behind the range or along the full countertop run. Counter Pro SD refers insured local fabricators who cut the backsplash panel during the same fabrication run as the countertop so the material matches exactly. Verify your fabricator's license at cslb.ca.gov.

(858) 925-5546 Request a quote

Quartz backsplash panel installed behind a range in a San Diego kitchen matching the countertop slab

What's included in this service?

Match homeowners with insured fabricators who include backsplash panel cutting in the same fabrication run as the countertop
Coordinate wall measurement during the countertop templating visit so the backsplash is cut to fit
Facilitate material matching so the backsplash panel is cut from the same slab as the countertop
Connect you with crews who handle adhesive application and silicone caulking at wall and counter joints
Arrange outlet cutouts in the backsplash panel where electrical outlets are located
Confirm the finished panel is flush and the joints are properly sealed before the crew leaves

When do you need this service?

You're installing a new quartz countertop and want a backsplash that matches rather than contrasting tile
Your existing tile backsplash was disturbed during countertop removal and needs to be replaced
You want a low-maintenance backsplash surface that wipes clean without scrubbing seams or lines
You're doing a full kitchen remodel and want a continuous stone look from the countertop to the upper cabinets
You want to add a four-inch slab backsplash strip behind the range to protect the wall with minimal upkeep

What do homeowners ask about Backsplash?

What is the standard height for a quartz backsplash?

The most common option is a full-height backsplash that runs from the countertop surface to the bottom of the upper cabinets, typically 18-20 inches. A shorter option is a four-inch slab strip that runs just above the countertop edge, which costs less but leaves the wall above it exposed and may require paint or another material above.

Can the backsplash be cut from the same quartz slab as my countertop?

Yes, and this is the recommended approach. Cutting both from the same slab ensures the color and pattern are an exact match. If the slab does not have enough square footage for both, the fabricator can source a piece from the same production lot, but there may be slight variation between lots.

How are electrical outlets handled in a quartz backsplash?

The fabricator cuts outlet openings in the panel during fabrication. This requires knowing the exact location and size of each outlet box before the panel is cut. Your electrician should install any new outlets before templating so the locations are captured accurately in the template.

Is a quartz backsplash easier to clean than tile?

Generally yes. A quartz backsplash is a continuous surface with no joints to accumulate grease, so it wipes clean with a damp cloth. Traditional backsplash materials with visible seams between sections require more frequent scrubbing, which is one of the main reasons homeowners choose a quartz slab panel instead.

Can I add a quartz backsplash to an existing countertop installed a year ago?

Yes, though it's more complicated than doing both at the same time. The fabricator would need to source quartz that matches your existing countertop, template the wall separately, and install the panel over or adjacent to the existing surface. Material matching is more difficult after the fact because production runs change over time.